CORC

浏览/检索结果: 共4条,第1-4条 帮助

限定条件    
已选(0)清除 条数/页:   排序方式:
Determination of optimum process parameters in gas-assisted injection molding (EI CONFERENCE) 会议论文
2011 International Conference on Electrical Information and Mechatronics, ICEIM2011, December 23, 2011 - December 25, 2011, Jiaozuo, China
Zi K.; Chen L.
收藏  |  浏览/下载:13/0  |  提交时间:2013/03/25
With finite element analysis software Moldflow  numerical simulation and studies about FM truck roof handle were conducted on gas-assisted injection molding process. The influences of melt pre-injection shot  gas pressure  delay time and melt temperature were observed by using multi-factor orthogonal experimental method. According to the analysis of the factors' impact on evaluation index  the optimized parameter combination is obtained. Therefore the optimization design of technological parameters is done. The results show that during the gas-assisted injection molding  optimum pre-injection shot is 94%  gas pressure is 15MPa  delay time is 0.5s  melt temperature is 240 C. This study provided a more practical approach for the gas-assisted injection molding process optimization.  
A comparison study on Gabor,Chirplet, FM(m)let atom databases for ECG signal processing 会议论文
3rd International Conference on Bioinformatics and Biomedical Engineering, JUN 11-16, 2009
作者:  Meng, QingJie;  Sun, Nongliang
收藏  |  浏览/下载:1/0  |  提交时间:2019/12/31
parallelization of fm-index 会议论文
10th IEEE International Conference on High Performance Computing and Communications, Dalian, PEOPLES R CHINA, SEP 25-27,
Zhang Di; Zhang Yunquan; Liu Shengfei; Huang Xiaodi
收藏  |  浏览/下载:11/0  |  提交时间:2011/06/13
efficient construction of fm-index using overlapping block processing for large scale texts 会议论文
29th European Conference in Information Retrieval Research (ECIR 2007), Rome, ITALY, APR 02-05,
Zhang Di; Zhang Yunquan; Chen Jing
收藏  |  浏览/下载:12/0  |  提交时间:2011/06/29


©版权所有 ©2017 CSpace - Powered by CSpace