QQ客服 官方微博 反馈留言

浏览/检索结果: 共1条，第1-1条 帮助 限定条件 专题：长春光学精密机械与物理研究所    第一署名单位    第一作者单位    通讯作者单位     已选(0)清除 条数/页：5101520253035404550556065707580859095100   排序方式：请选择作者升序作者降序题名升序题名降序发表日期升序发表日期降序提交时间升序提交时间降序 Simulations and experimental studies of diffuser/nozzle pumps (EI CONFERENCE) 会议论文 4th International Symposium on Precision Mechanical Measurements, August 25, 2008 - August 29, 2009, Hefei/Jiuhua Mountain, Anhui, China Bai L.; Feng Z.; Wu Y.; Li W. 收藏  |  浏览/下载：18/0  |  提交时间：2013/03/25 An investigation of diffuser/nozzle micropumps is presented. Numerical simulations are done using CFD program ANSYS/Flotran. The simulations show when the opening angel is small  the flow in the diffuser/nozzle is steady  the mass flow is increasing with the adding opening angle. But when the opening angel continues increasing  the pressure grads will be bigger than zero. It means that the static pressure is gradually going up along the diverging direction. The fluid near the wall stops flowing because the velocity decreases rapidly and the dynamic pressure is not big enough to overcome the increasing of the static pressure. Finally the fluid flows reversely from the backward position of higher pressure area  this makes the separation flow of fluid  the diffuser is full of reverse fluid. And this results in the dropping of mass flow at last. The simulations also show that the performance of diffuser with a round inlet is better than that with a sharp inlet. The mass flow of micropumps with different opening angles  different inlets are measured. The experimental results agree well with the simulations. 2008 SPIE.