QQ客服 官方微博 反馈留言

浏览/检索结果: 共3条，第1-3条 帮助 限定条件 内容类型：会议论文    专题：长春光学精密机械与物理研究所    第一署名单位    第一作者单位    通讯作者单位     已选(0)清除 条数/页：5101520253035404550556065707580859095100   排序方式：请选择作者升序作者降序题名升序题名降序发表日期升序发表日期降序提交时间升序提交时间降序 Design of motion adjusting system for space camera based on ultrasonic motor (EI CONFERENCE) 会议论文 International Symposium on Photoelectronic Detection and Imaging 2011: Space Exploration Technologies and Applications, May 24, 2011 - May 26, 2011, Beijing, China Xu K.; Jin G.; Gu S.; Yan Y.; Sun Z. 收藏  |  浏览/下载：74/0  |  提交时间：2013/03/25 Drift angle is a transverse intersection angle of vector of image motion of the space camera. Adjusting the angle could reduce the influence on image quality. Ultrasonic motor (USM) is a new type of actuator using ultrasonic wave stimulated by piezoelectric ceramics. They have many advantages in comparison with conventional electromagnetic motors. In this paper  some improvement was designed for control system of drift adjusting mechanism. Based on ultrasonic motor T-60 was designed the drift adjusting system  which is composed of the drift adjusting mechanical frame  the ultrasonic motor  the driver of Ultrasonic Motor  the photoelectric encoder and the drift adjusting controller. The TMS320F28335 DSP was adopted as the calculation and control processor  photoelectric encoder was used as sensor of position closed loop system and the voltage driving circuit designed as generator of ultrasonic wave. It was built the mathematic model of drive circuit of the ultrasonic motor T-60 using matlab modules. In order to verify the validity of the drift adjusting system  was introduced the source of the disturbance  and made simulation analysis. It designed the control systems of motor drive for drift adjusting system with the improved PID control. The drift angle adjusting system has such advantages as the small space  simple configuration  high position control precision  fine repeatability  self locking property and low powers. It showed that the system could accomplish the mission of drift angle adjusting excellent. 2011 SPIE.   Analysis of inertia dyadic uncertainty for small agile satellite with control moment gyros (EI CONFERENCE) 会议论文 2010 IEEE International Conference on Mechatronics and Automation, ICMA 2010, August 4, 2010 - August 7, 2010, Xi'an, China Sun Z.; Zhang L.; Jin G.; Yang X. 收藏  |  浏览/下载：12/0  |  提交时间：2013/03/25 With the increasing demands for the agility of the next earth imaging satellite  control moment gyro (CMG) is considered to be the most suitable actuator because of its torque amplification capability. However  a CMG system may introduce uncertainty of inertia dyadic to a satellite's attitude control system. The uncertainty is negligible for large space vehicles  but it has not been tested whether it can be ignored for small agile satellites. How to model the CMG system inertia dyadic varying with gimbal angles  and what influence it will put on the performance of attitude control system haven't been test accurately as well. All of them are dealt with mathematically and accurately in this paper. This paper firstly gives mathematic descriptions of the inertia dyadic of the 4-CMG pyramid configuration system  varying with gimbal angles  and then designs a variable structure control law for small agile satellite using CMGs. Finally  numerical simulation suggests that the inertia dyadic variation of a 4-CMG pyramid configuration system is approximately centesimal of the total inertia dyadic of the satellite  and that the designed variable structure control law is of good robust performance for an example of large-angle attitude maneuver  despite of the variation of the inertia dyadic. 2010 IEEE.   Proposal and investigation for a planar MOEMS 18 wavelength-selective switch (EI CONFERENCE) 会议论文 MEMS/MOEMS Technologies and Applications III, November 12, 2007 - November 14, 2007, Beijing, China Li X.; Liang J.; Sun D.; Zhong Y.; Li W.; Liang Z. 收藏  |  浏览/下载：95/0  |  提交时间：2013/03/25 This paper presents a new wavelength-selective switch by combining silicon micromaching and microassembly techniques. The 18 wavelength-selective switch (WSS) based on micro electro mechanical systems (MEMS) technology is proposed and fabricated with micro electromagnetic actuators  8 WXC prototype node is implemented by using 18 WSSs as building elements. The working principle and the configuration of the micro electromagnetic actuator are illuminated. By analysis  reflecting prisms and narrow-band thin films filters. And a 8  the property suits for the application when the inputs are 2V  and the best fiber-to-fiber insertion loss 5dB is gotten.