微灌压力调节器调压特性流固耦合数值计算及分析
李连忠 ; 牛文全 ; 魏正英 ; 谢巧丽 ; 周兴
刊名西 安 交 通 大 学 学 报
2013
卷号47期号:05页码:131-06
关键词压力调节器 pressure regulator 调压特性 regulating characteristics 流固耦合 fluid-structure interaction 数值计算 numerical
其他题名Numerical Simulation on Regulating Characteristics of Pressure Regulator
中文摘要 针对微灌压力调节器在调压过程中内部压力、速度分布及调节组件运动状况等特性难以用传统方法分析的问题,采用流固耦合方法进行了数值计算。通过对比数值计算与实验结果发现,进出口压力的最小相对误差为0.98%,最大相对误差为14.28%,流量的相对误差为6.19%,从而验证了流固耦合方法的可行性。在此基础上,对压力调节器内部压力、速度分布以及调节组件的轴向位移趋势等特性进行了分析,结果表明:稳定工作状态下压力损失主要发生在调节组件与进口花篮堵头之间,压力损失占进口压力的28.13%~34.17%,该值随着进口压力的增加而增大;进口压力达到一定值后,调节组件的轴向位移随进口压力的增加而增大,最后稳定在13mm~13.8mm之间并呈波动性变化。所得结果可为微灌压力调节器设计提供参考。
英文摘要Abstract:It is difficult to analyze the characteristics of pressure regulator in micro-irrigation
systems during regulating,such as the distributions of internal pressure and velocity,and the
movement features of the regulating components,by the traditional methods.Numerical
simulations for these processes are conducted following fluid structure interaction consideration.
A comparison between the simulated and experimental results of pressure and flow rate indicates
that the minimum relative error for pressure gets to 0.98%and the maximum to 14.28%;the
relative error for flow rate to 6.19%.The distributions of velocity and pressure in pressure
regulator,and the axial displacement of regulating component are computationally analyzed.It is
found that the pressure loss occurred mainly between the regulating part and the block cap for
steady working state.The ratio of pressure loss to the inlet pressure is ranged from 28.13%to
34.17%and increases with the inlet pressure.When the inlet pressure reaches a certain value,
the axial displacement of the regulating part increases with the inlet pressure and finally stabilizes
and varies undulatingly within 13to 13.8mm.
语种中文
公开日期2014-10-21
内容类型期刊论文
源URL[http://ir.iswc.ac.cn/handle/361005/5598]  
专题水土保持研究所_水保所知识产出(1956-2013)
推荐引用方式
GB/T 7714
李连忠,牛文全,魏正英,等. 微灌压力调节器调压特性流固耦合数值计算及分析[J]. 西 安 交 通 大 学 学 报,2013,47(05):131-06.
APA 李连忠,牛文全,魏正英,谢巧丽,&周兴.(2013).微灌压力调节器调压特性流固耦合数值计算及分析.西 安 交 通 大 学 学 报,47(05),131-06.
MLA 李连忠,et al."微灌压力调节器调压特性流固耦合数值计算及分析".西 安 交 通 大 学 学 报 47.05(2013):131-06.
个性服务
查看访问统计
相关权益政策
暂无数据
收藏/分享
所有评论 (0)
暂无评论
 

除非特别说明,本系统中所有内容都受版权保护,并保留所有权利。


©版权所有 ©2017 CSpace - Powered by CSpace